[Daler69]

Hey guys

I finally got around to having my car fully aligned by way of a 'Hunters' system. All wheels were out in every way possible. Now all are fine except the drive rear wheel is still a little toe out because we ran out of adjustment! Bushes look good but i still have droning from the back end, I brought new rear wheel bearings but didnt want to install them yet as i didnt want the tracking to knock them out again.. Will a knackered wheel bearing cause the toe angle to be so far out or am i looking at a twisted chassis?? :confused

 

[keith M5]

If the bearing was that bad there would be so much play and noise from it, you would be in no doubt. If there is still toe out it is more likely a bent arm, hub, knackered or incorrectly fitted bush. Chassis damage is unlikely.