BMW Forums : BimmerForums banner
remains
1-7 of 7 Results
  1. BMW 8 Series Forum - Technical Talk on the BMW E31
    Just changed relay in boot to get interior lights working, successfully, but now the gear selector light denoting its in park is lit and remained on after switching off ignition. Is this normal or do I have another (minor) problem?
  2. BMW 3 Series - Tech Talk For All Gen Of 3 Series
    2005 e91 330d M Sport - Loss of Power above 2000 RPM - Turbo Actuator Code. Turbo now replaced but fault remains I've had an intermittent loss of power above 2000 rpm on my 2005 e91 330d (109k miles) for the last 3-4 months. Below this RPM it is normal but when the Turbo should kick in there...
  3. BMW 5 Series Forum - Technical Talk on the BMW E12
    I am restoring a 1992 3.8 M5, it has had the nurburgring suspension removed including electronics etc. It now has conventional springs and bilsteins etc etc. Anyone got rid of the ghost message re "go to workshop" "edc failure" or similar. From help it appears I still have the parameters...
  4. BMW 3 Series Forum - Technical Talk on the BMW E46
    I am new to this forum, and I have just bought my first BMW. It is a very well kept 320d Touring from 2001. The previous owner had navigation mounted on the dashboard and as I do not use the navigation much, I would like to remove it. But how do I do it? The "holder" for the navigation seems to...
  5. BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi all, put the car in the garage tonight and noticed that the gear selector light (next to "P") remaind on. Have not had the car too long but not sure if this is normal. Is this a fault? Thanks for any help. Richard
  6. BMW 5 Series - Tech Talk For All Gen Of 5 Series
    The ASC light came on whilst driving which I believe means the system is switched off. So that means I am unable to switch it on. Any ideas?
  7. BMW 3 Series Forum - Technical Talk on the BMW E46
    The aircon blower remains on after the engine is switched off. None of the instruments on the aircon panel operate but the display still shows the temperature reading. If the blower fuse is removed it turns off but the display is still on. How do I get the fan and display to work properly?
1-7 of 7 Results
Top