BMW Forums : BimmerForums banner

plausibility

  1. E46 320d 4560 error rail pressure plausibility delivery controlled

    General BMW Discussions
    Hi, I have a problem with e46 320d 2002 150cp, the car doesen't have power anymore (doesen't smoke or some error on dme) and first time I say turbo is gone. I buy a second hand turbo, i change it and still same problem no power and after that when i try to accelerate hard DDE light it's come on...
  2. noob needs help - 330d fueling issue

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi everyone, Not had my 330d long and been loving it up to now. Occasionally when I put my foot down the car enters limp mode. See below an INPA readout of the faults https://postimg.org/gallery/2pjysmhh8/ I've changed the fuel filter with no effect. Any help would be much appreciated...
  3. 2000 E46 330d - 4496 Rail-pressure plausibility / 2550 Rail Pressure control at start

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Car died on way home from work tonight. Drop in power and a smell of diesel in the car. DDE light on. Pulled up on drive, turned off engine and it wouldn't fire up again. Took off inlet manifold and plenty of fuel on the rocker cover, no visible signs of where it has come from? Plugged it...
  4. E92 N57 325D 2011 / Swirl Flap Plausibility

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi, Ok, this topic seems to an issue that's been well talked about, the solution seems to be to buy & install blanking plates as a preventive measure, on older models. But how about a 2011 325d ? I recently bought a obd adaptor to code some features on the car & I also ran diagnostics after...
  5. Won't start when engine warm. Rail-pressure plausibility INPA code.

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi guys. I think there are two related problems but I cannot find the cause! 1. If the engine is cold I can start it. If a bit warm, it starts but after some cranking. If hot (90deg) it cranks but I cannot start it. I can start it again if I leave it 15 min to cool down. 2. If I floor it I get...
  6. Rail pressure plausibility error, e39 530d touring

    BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hello,greetings from Latvia,so dont be harsh on my eng. I will start with this,In this morning i was driveing on higway,engine was cold ~30-40c°..after speeding up i get "dong" and fuel injection system error,i pulled off the road and the car (engine) was shakeing,like i pluged off 1 or 2...
  7. Non Plausibile plausibility sensor

    General BMW Discussions
    Hi I have a 316ti auto 2003. Ive had a bit of rough running recently which is exagerated if you blip the throttle. Acceleration is flat and yesterday two coil packs failed. I took it to a BMW independent who replaced all 4 packs. Diagnostic fault code read intake manifold plausibility sensor...
  8. 4496 Rail pressure plausibility?

    General BMW Discussions
    Im having cut out problems during heavy acceleration. Read the codes... 4496 Rail pressure plausibility Engine speed 3721 Pre supply 2.74 bar Einspritnange 59.40 RPC rail pressure 259.04 It has had a new HP pump 2 months ago Would i be right in saying that its the in tank pump thats shot...
  9. 2004 E46 316ti - Plausibility diff. pressure sensor(FIXED)

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi there, I'm starting a new thread about this as my previous one went a little off base so i wanted to get this all down into one area. Since i've had the car i've had occasionally starting problems and intermittent cutouts. Basically i turn the key and sometimes it will rev up to 1000 and...
  10. 323i E46 1999 - Plausibility, signal, brake-light switch/brake test switch

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi have a 323i E46 1999 Auto witch has a error in the Auto display in the dash that reads in the manual as a transmission system fault. So i had the car plug up to a Lunch witch came up with the Plausibility , signal, brake-light switch/brake test switch. Now this didn't read a fault code just...
Top