BMW Forums : BimmerForums banner

p0011

  1. BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi. My 2002 e46 is showing Fault Codes P0011 and P0366 when I hook up the obdc2 to it. The symptoms of the car are it's got a bit of lag when sticking your foot down. Also there is a definite lack of power. A ford focus driven by the wife pulls away from me and I just can't keep up. The...
  2. BMW 3 Series Forum - Technical Talk on the BMW E46
    I recently got my e46 few weeks back and trying to restore the thing. It is in an indy shop for a good 4 days straight now because I am having the following done: front and rear bushings/ball joints/links replacement front crankshaft oil seal replacement differential oil change, brake fluid...
  3. BMW X Series - Tech Talk For All Gen Of X Series
    Hi. Iv posted on this great forum before so I know someone out There will possibly save me. I have a 2002 3.0 ltr petrol x5, I had a spot of bother last year with an unhappy engine, new head now on and has been purring for a year now, no hickups or warning lights have come on until Monday...
  4. BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi folks, Having some trouble with rough idling and stalling. The car appears to idle fine until warmed up. When coming to a stop, the car will stall. Timing chain and tensioner were done by a garage 4 months ago (3 month warranty). I replaced the solenoid o rings this morning and topped...
  5. BMW 3 Series Forum - Technical Talk on the BMW E46
    Hello! I have a BMW 318 E46 -02, motor N42. The swedish vehicle inspection has not approved my car because of following error codes: • P0011 Camshaft Position (A) - Timing Over-Advanced or System Performance (Bank 1) • P0341 Camshaft Position Sensor Circuit Range/Performance (Bank 1) With my own...
  6. BMW 1 Series - Tech Talk For All Gen Of 1 Series
    Hi all, Im new here and have joined because my BMW 116i 2005 has a problem and could do with some help please. All of a sudden yesterday the car started jumping and stuttering under higher revs, the issue got worse so I pulled over and called the AA. The following error code came up P0011 and...
  7. BMW 3 Series Forum - Technical Talk on the BMW E46
    I have tried searching the forums, and think I have come up with the need to replace Camshaft Position sensors on both the inlet and exhaust side going by my codes. However just would like a sense check from someone who knows these cars. My car is 2001 and recently had Head gasket replaced...
  8. BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi. I have owned my 2002 318i with 75k on the clock for a few months now with no problems, but a few days ago i was driving along and with no warning the engine started to run rough and lost a lot of power. I managed to limp it home (about 1/4 mile luckily) and began to inspect it. It is idling...
  9. Diagnostic Hardware and Software Discussion forum
    hi Guys, i need some help....ive been suffering from a couple of problem recently.... firstly the temperature gauge just takes ages to get to 12 o clock position and then flucuates up and down..... secondly the engine cuts out whilst im in idle or a traffic lights for example....it doesnt...
Top