BMW Forums : BimmerForums banner

manifold

  1. 320d intake manifold cleaning

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi all, New to the site. Just taken off my intake manifold to check that previous owner was telling the truth about swirl flap delete, luckily he was! However intake is caked (not bad for 200k though) and want to give it a clean, anybody done this first hand? Had a quote from local engine...
  2. E90 320d injector issues after cleaning inlet manifold.

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi all. Hope someone can help. Had abit of a nightmare time recently. I decided to take my inlet manifold of my 320d 2005 e90 to clean it. After putting it back on the damn thing didn't want to start. However, after many attempts cranking it finally jumped into life. But ran rough. So I...
  3. E39 - M54 Intake manifold runner control unit O-rin

    BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hi guys, could anybody please suggest me what kind of O-ring to use to seal this unit? I took it out and it looks like it needs a new one.
  4. E70 intake manifold torque settings

    BMW X Series - Tech Talk For All Gen Of X Series
    Hi all Just about to reinstall my intake manifold on a 2008 x5 3 litre diesel and wondered what the torque settings were for the bolts and the nuts Any help appreciated Cheers Adrian
  5. Inlet Manifold Question... Mistakes were made.

    BMW 3 Series Forum - Technical Talk on the BMW E46
    On the off chance anyone else has had a similar experience I thought I would ask. Unlikely I suspect, but here goes... I sheared one of the bolts refitting the inlet manifold. These are captive in the manifold housing. Is it possible to replace these or will it be easier to replace the whole...
  6. 2007 E91 318D M47 - P0401 Fault Code After Cleaning Inlet Manifold and EGR Valve

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi I recently purchased a 2007 318D with M47 engine and following a bit of reading decided to give it some TLC by cleaning the inlet manifold and EGR valve. It's all back together and runs ok except for the nasty fault code - P0401 Exhaust Gas Recirculation Flow Insufficient Detected. In my...
  7. BMW E36 318is - m42/44 exhaust manifold

    BMW 3 Series Forum - Technical Talk on the BMW E21
    Hi guys, Praying for some help on this topic which has no doubt been covered extensively somewhere so apologies. After some questions I've discovered my engine is the M42B18 engine (I thought it was the M44). My questions now are; 1) Is the M42 a twim cam engine? 2) I can only find M44...
  8. Anti shudder valve manifold connecter

    BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hey guys! New here so heelllloo! Wondering if anyone can help me out. I have a 2005 525d basic model and nothing fancy. Tiny little alloys 😂😂. I've just removed my inlet manifold to change my glow plugs. Everything went well apart from now my anti shudder valve appears to not be working 🤔...
  9. Need help finding Inlet Manifold N47 320D 2008

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    No longer required. Delete post
  10. E34 Intake Manifold

    BMW 5 Series Forum - Technical Talk on the BMW E12
    I have transplanted an E34 535i from an Alpina B10 3.5 into an E9 coupe. I did not fit the engine. I have recently taken the manifold off and there are two small pipes sticking out of the bottom which are not connected. They are obviously an air leak so the engine isn't running correctly, but...
  11. X3 F25 3.0d Melted Inlet Manifold

    BMW X Series - Tech Talk For All Gen Of X Series
    I have a 2011 X3 F25 3.0d with 70000 miles on it which has an inlet manifold with multiple small areas which have melted. The manifold has been under boost pressure at the time as the material has been pushed out from the inside of the manifold. The fault manifested itself as a burning smell...
  12. F30 330d cracked inlet manifold

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    So cars been into bmw again after the failed repair last week. Last week they replaced the egr cooler which they claimed was cracked (I never saw this and they didn't send me a video either). That cost me £750 which didn't cure the symptoms I had at all. Now they're telling my I have a cracked...
  13. Exhaust Manifold Replacement

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi, I hope everyone is well. I needed some help. I have searched HIGH and low on the internet for a DIY for an exhaust manifold replacement but i have found nothing.... ABSOLUTELY nothing anywhere. Does anyone have a DIY of how to change my exhausy manifold on my 2005 320cd. It is a covertible...
  14. M50B25 vs M50TUB25 Intake manifold

    BMW 5 Series Forum - Technical Talk on the BMW E12
    So I plan on swapping M52B28 into my e34 and I wanted to do the M50 intake manifold conversion. What I noticed that part numbers for M50 manifold are the same for M50TUB25, M50TUB20 and M50B20. The only different number is for M50B25. So is the only reasonable option the M50B25 manifold? Part...
  15. Blowing exhaust? Leaking manifold?

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Today I noticed a pretty deep blurb noise on my 320d when starting the car. It was followed with a few second on whining and then got to normal but I noticed that it was running louder than normal. When stopping the car I could also hear veru deep sound just before the engine shut off followed...
  16. E53 starting issue after manifold change

    BMW X Series - Tech Talk For All Gen Of X Series
    Hello. I have just spent the almost the entire weekend stripping back my 2006 x5 3.0d to replace a badly cracked exhaust manifold. I have put everything back exactly as it came off including the order of the injectors however when I try and start it it turns over but cuts out immediately. I have...
  17. Will a E34 325TDS Manifold fit on a E36 325TDS ??!

    BMW 3 Series Forum - Technical Talk on the BMW E21
    Will a E34 325TDS Exhaust Manifold fit on a E36 325TDS ??! Want to have a top Mount turbo set up for a future turbo upgrade so it can accomadate for the size of the turbo upgrade 👍🏼 Wondering if the bolt pattern of the manifold off a e34 TDS will be the same as a e36 TDS Head ? Direct bolt on...
  18. 1 valve let's the air through, the rest 5 not - Intake Manifold M57 3.0

    BMW 5 Series - Tech Talk For All Gen Of 5 Series
    So basically, removing intake manifold, I vacuumed the holes making sure nothing fell there and 1 valve or hole in the intake was letting air through the other hole, and the rest 5 holes, didn't let it....and this happened twice where in the meantime, I started engine couple of times before...
  19. M57 3.0d Intake Manifold sealant questions.

    BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hello, so since I still have swirl flaps in place and don't plan to removing them (i dont want to lower torque and increase consumption even by that little), my intake manifold is leaking oil and potentially some boost i assume, so without thinking about it twice, I bought gasket sealant in a...
  20. 1989 E30 320i how to repair Round multi plug under inlet manifold - wiring

    BMW Garages and Parts Retailers
    1989 E30 320i - how to repair round multi plug and wiring under inlet manifold. is the wiring available or possible to repair
Top