errors

Advice? N53 on 2007 E61 LCI 523i - EML light on - High & low fuel pressure errors & lambda sensor/probe warnings? Looking for advice on the most likely cause of this EML light. My 2007 E61 LCI manual with N53 engine has covered 199k km (123k miles) The EML came on a few days ago on...

i have a 2006 e63 650i soft top came in with restraint system faults fault codes were internal error and 93c1 occupancy mat these would not clear using launch i replaced the pad with a occupancy emulator then sent ecu off to be repaired he fixed the internal error got it back all ok except...

Hi all, Im having multiple issues with error codes on my 2008 e60 520d m sport lci with 150k miles on the clock. Ive read all the codes using INPA and DIS. The codes are as follows; DDE Diesel Electronics OL 4B1C Fuel Filter Heating, activation 4C5E Particulate filter system minimum...

Hi everyone my name is Josip. Yesterday I've removed the DPF out of my 320d and reconnected the 2 sensors + 1 hose back to the new downpipe. I'm wondering why am I not getting any errors on ECU. I tried reading the codes with Delphi and it's showing only auxilliary water pump which is known...

Hi to everyone I’m new here. I have a E90 320d. Some time ago I decided to retrofit the steering multifunction switch so I bought from ebay the LCi switch cluster (in the pic) and also the multifunction switch. I install and everything it’s working fine but I have the traction control light in...

Hi, I had my car carbon cleaned and EGR deleted by the ecu and a remap on Tuesday, before hand I read the codes and cleared them and then rescanned it a few days prior to the work being carried out. I've scanned it today and have all these errors. Are they related to the remap and carbon...

Considering to buy a 2007 e70 with k-can errors and water damage on a auction. Are what do you guys think? Is it worth it? Or is it a lost case? Car is only driven less den 100k mils. And had the engine replaced 10k ago. Are the k-can errors hard to lokalice? Did a scan on the car. Lots and...

Hey, So im starting to become an expert in removing the intake manifold.... 2 month ago Carly said 6 plugs were broken (4212,4222,4232,4242,4252 and 4262) Looked around on this forum and found the answer quite quickly, ordered new plugs + module and changed. ONE start later and carly said 3...

Hi guys, Hope you all had a great christmas. I'll jump straight to it iv had my car for a while and everytime i start it the car shakes and sometimes cuts out on a cold start with a rough idle. I have had lots of blue smoke over the last few days. Iv recently had all the glow plugs changed as...

Is anyone able to advise with the error codes that have been picked up by INPA on my E90 330D? Codes are: 4212 4232 4233 4242 4243 4252 4223 I'm going to assume that the glow plug control unit is out, rather than the individual glow plugs? Also, my car has 95k on the clock. If i'm in the...

Hi I got a 2002 BMW E46 320i few weeks back. The DSC, ABS and brake light came on. To find out what's wrong, I ordered an INPA OBD2 cable. I didn't have access to a CD drive so I couldn't install the software from the CD which came with the cable. I found the software online and installed it. At...

Anyone good with CCC? I have these errors and not really found any helpful information If anyone can help that would be great

Hi all, I have a BMW E46 318i from 2003 with an N42 engine. I replaced the timing chain, guides, tensioner and the crankshaft sensor last summer, but since then I had an P0341 which has always come back at the next engine start after deleting. The car drove OK until now and I did not really...

Hello, I've recently bought a 2012 F30 320D Auto and looking to do a bit of coding. I've got some experince on my old E46 but having a few issues with the F30. I've got the cable and downloaded ESYS Version 3.28.1 (Build 46869) and PSdZ Version 5.02.00-2016-09-20T08:59:28Z. I've been able to...

Hi I have glow plug errors on cylinders 2, 3 & 4 on my car. This was using Carly. I'm thinking I might as well change all of them as one more won't make much difference money or time wise. Where is the best place to get the glow plugs? I imagine the main dealers will be quite costly. Mick

Hi everyone, this is my first time on this site and my very first post sorry if it is in the wrong place. I have heard great things about this site and how helpful the members of this forum are. My wife owns a 2006 BMW E90 320d M47n2 it has 79k miles and a full service history. We have owned...

Just got my new diagnostic cable and upon giving the car a going over all I can find between INPA and DIS are the following codes. These are both current as I had cleared them. I had noticed the xenon lights don't do their short moving sequence when first turned on so figured a sensor may...

Hello i got this errors on my e39 525d . Can somebody tell me what is it ? 000001 STH Temperature senaor 000003 STH circulating pump 000007 STH undervoltage deactivation

Hello friends, I am still having problems with the N43 engine. After eliminating the Nox catalytic converter almost a month ago, the car ran fine for a couple o days, then the CEL and limp mode happened. Errors found: 2a99 crankshaft,exhaust camshaft,reference 2A87 VANOS exhaust- stiff...

Hi everyone Im new to the forum :) I have a strange problem with PDC on my 2005 e60 i bought it not long ago and there is no beeping from the speakers when close to obstacle on front the rear, the strange thing is I have no faults on I drive or OBD computer, the screen comes up on I drive and...