BMW Forums : BimmerForums banner

eeprom

  1. Auto Electrical Forum
    Hi, I'm trying to fault find an issue with my BMW 1 series 118i 2006. I keep getting a code at random 2A61 Valvetronic Learning. Upon translation I see that the error relates to not being able to write the adaptation values to the EEPROM. Does this point to a faulty EEPROM in the DME? Or other...
  2. BMW ECU Tuning and Standalone Tuning
    My e46 330d has dde4 p1361 eeprom checksum fault.I've been told its either down to not havin vin put into a module or dde ews not set up properly.I'm trying to get to grips with ncs expert/winkfp etc BTW and wondering if there's any way of fixing this error. Was on another site and a helpful...
  3. BMW Z Series - Tech Talk Z1, Z3, Z4, Z8, Z9
    Hi all, newbie here, great to be a part of the community - I just became the proud owner of a 2001 Z3 2.2i sport. :D All seems in order mechanically and aesthetically, however it shows EEP2 error and the instruments don't work when it is stone cold. If turned off and on again after a couple of...
  4. General BMW Discussions
    Hello everybody. I have 2001 320d 136 car. The problem is that I have huge loss of power before turbo until 1700 or 1800 rpm. It has shown control unit(dde eeprom) fault. However I have serviced my bosch pump couple of months ago and it makes me question whether the problem is in ECU or the...
  5. BMW 5 Series - Tech Talk For All Gen Of 5 Series
    good day, so i have a situation and i hoped that maybe somebody will guide me to the right path. i have bought an engine from a range rover (M57) and i have put it to my E39. i just needed to swap oil pump and a sump, the rest was bolt on. Engine works, no bad sounds or leakages, but it misses...
  6. BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hi, i messed up and need an Ike file dump from an 535i 98, do any of you guys got them files to the model? If i get an ike file from an other car do i need to change the mileage or is it the right mileage right away? Please if any one got a file dump for this model i beg of you to upload it. If...
  7. BMW Tuning Forum
    Hello, does anyone know anything about this problem? "1640 DDE Error EEPROM or Coding".Its a 525 diesel from 2002. The engine runs ok (I think so) until I switch on the A/C and then the whole car start to shake quite badly:jaw-dropping. A few mechanics said the engine has been remapped (I bought...
  8. BFuk Open Topic
    Hi. Can anybody tell me where I can buy a couple of 93cs56 EEPROM's. I've been searching for days. Thanks. Pete.
  9. Diagnostic Hardware and Software Discussion forum
    Hi. I need Lew (Steering angle sensor) Eeprom files for e39 525i M54B25, manual, 09.2001., euro model. I would appreciate if someone can give them to me, since I deleted my by mistake. Thanks. :thumbsup
  10. BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hi! I have an old HW04/SW09 Video module, which doesn't support 16:9 at all (no aspect ratio switch option). I'd like to upgrade my eeprom for a newer one. I heard that HW04/SW11 supports 16:9 already. So I am looking for that or newer eeprom, or maybe if you know the first SW version which...
  11. BMW Garages and Parts Retailers
    hi everyone im after a tuner who is able to tune the eeprom chip on my 1991 325i non vanos m50 engine, just need the rpm limit extended and timing retarded by a few degrees across the entire rpm range. can anyone recommend someone reliable and well priced? any help would be appreciated. thanks
  12. BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hi folks. As per this thread here, I am in the process of trying to reprogram my corrupted Instrument Cluster EEPROM. I now have the necessary hardware and software to allow me to do this (cables, a dongle and BMW Scanner) and I have been able to log into my Instrument Cluster and have a look...
  13. BMW 5 Series - Tech Talk For All Gen Of 5 Series
    ***GO TO POST ~18 OF THIS THREAD FOR SOLUTION*** Evening all I've seemingly contrived, through a farcical comedy of errors, to kill/corrupt the EEPROM on my E39. I think I did this by stupidly (I know, I know!) trying to jumpstart the car by connecting jumpleads directly to the battery in the...
Top