BMW Forums : BimmerForums banner

crank

  1. Bmw 330D E46 Crank no start Help!!

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi guys i have a bmw 330d 2004 msport auto and i have a problem with the car The Problem is that the car was running fine the day before, next morning i started the car and drove about a mile when the car just cut on me, and has not started since So fari have replaced the in tank fuel pump...
  2. 2004 E46 318ci (N46), Manual - Crank but no start even after new fuel pump and filter

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hello guys, I have been having a bit of a nightmare with my car lately, I had to be recovered twice and car is with the garage still. I have a "crank but no start" issue, which was fixed (car worked fine for a day) and then happened again. Car was working fine and then one morning it would...
  3. E70 X5 Crank, No start.

    BMW X Series - Tech Talk For All Gen Of X Series
    HI guys after some help. I have a 2008 X5 3.0d cut out whilst driving last week and now wont restart. Fuel was low so I filled up and tried starting but just a strong crank but no start. I plugged ISTA in and checked for errors and nothing to report. I have checked that low pressure pump and...
  4. Long Crank but instant on "Stop/Start"

    BMW 1 Series - Tech Talk For All Gen Of 1 Series
    Hi My 2008 E88 has a long crank. Starts nearer the end of the first start cycle - may be two seconds (seems like long time...). It does, however, start instantly when the auto stop/start system is in use (ie when I forget to turn it off). The Vanos things have been cleaned (they weren't...
  5. E46 n42b20a crank no start beep identification

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi, There is a constant beeping and then a clunk coming from the passenger side of engine after crank no start. Can this be identified by this alone? Appreciate it if anybody can say what this indicates. Initially CCV needed replacing, so I replaced most of the seals and gaskets I could get...
  6. Late e36 323 crank sensor HELP!

    BMW 3 Series Forum - Technical Talk on the BMW E21
    Hi, having a problem with my e36 323 (late 98 model) Basically it needs a crank sensor, cant get a direct replacement from anywhere. So i started looking in to why i couldn't get 1. I found that apparently BMW did a loom and sensor conversion back in the day. Does anyone thow about this? TIA Rob.
  7. N53 Lower crank cradle bed plate sealer

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi just wondering if there is an alternative sealer for the lower crank bed plate to this stuff 83190439030 for the n53 engine reason being I'm finding it hard to locate any nearer than America thanks
  8. BMW E91 330d long crank and rought start when cold outside.

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hello guys I have a BMW E91 330d that suffers with long crank and rought start when cold outside. No fault codes. 6 new glowplugs, new glow plug relay and new cable to relay. Car starts with no issue when warm, and when warmer outside. Where do I start?
  9. Stats fixed but now it looks like I have turbo and maybe crank breather problems?

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    2006 E91 320d - Today I changed both the EGR stat and the main stat. The EGR one was faulty but I think the main one was actually ok although it got replaced anyway. While I had bits off I also cleaned out the EGR valve and fixed the vacuum feed hose. After a 5 mile run it is now behaving a lot...
  10. Idle fluctuation and long crank issue only when slight warm

    BMW 5 Series - Tech Talk For All Gen Of 5 Series
    So it goes like this, and the car is a 530d Automatic 2005: 1. When the car is dead cold, even at -16 C, starts perfectly, idle is steady, crank is super short, basically, everything works perfect. 2. Now, after I drive like 7km, so the engine gets barely warmed up, all the troubles start, as...
  11. Bottom end rebuild using crank and pistons from old engine

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi all I just need some advice on using my old crank and pistons in my second engine as I've found that 5 rod bearings have been rotating and knackered the crank and rods my problem is when I disassembled my first engine I never kept the pistons in order and I'm having trouble finding what...
  12. 2000 E46 320d no crank

    BMW 3 Series Forum - Technical Talk on the BMW E46
    320d does not crank, does not click. Bump starts just fine. After a small drive the starter works, but if I leave the car for like 6 hours. No click, no start, again. Once, during the time of the issue, it worked in the morning as well, but just once. Ews module clicks , when the key is put in...
  13. crank but wont start (help)

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    im hoping to resolved this issue here as i determine to get to the bottom of this:confused 2010 E90 m sport 335d which was parked for about a year ..it usually starts 1st time till the battery died during the cold weather - i replaced the battery turn engine turns but wont start ...
  14. Crank pulley failure symptoms?

    BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Anyone know what the normal symptoms are with a failing crank pulley? When I slow down, mainly in stop start traffic in my e91 320d m47 auto, I get what sounds like a heavy vibration which then disappears when I start pulling away. Only happens when I slow right down and nearly come to a stop.
  15. F11 (2011) - N47 Crank seal leak front

    BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hello there I have noticed an oil leak on my F11 2011 N47 engine. It seems to coming from crankshaft seal on the front. I have removed crank pulley. I was trying to find a tool to remove the seal but I cant find any for N47 engine. There ale tools for pretty much any other engine but not N47...
  16. 2006 X3 M47 2.0d crank shaft sensor replacement

    BMW X Series - Tech Talk For All Gen Of X Series
    Hi all, My X3 died on a french motorway about 10,000 miles ago, like turning off the ignition at 80 mph, restarted okay and we drove home (feeling slightly nervous) The Fox scanner revealed no related fault codes, though had loads backed up for other things, lights, windows, etc, which I...
  17. Help needed crank pulley removal problem e60 530d

    BMW 5 Series - Tech Talk For All Gen Of 5 Series
    Hi Guys, Any help would be appreciated. I am fully able to do this job in under an hr usually but have lost my locking pin for the flywheel. I borrowed one from a mate who says it is defo correct one and took out my fan, belts etc. I then took off the cover for the flywheel locking pin to go...
  18. Crank but no start

    BMW 3 Series Forum - Technical Talk on the BMW E46
    Hi all. Hope you can help. Ive got a 318i e46 touring automatic, 2004 plate. It intermittently won’t start first in the morning. However if left until later it starts. The weather conditions doesn’t make a difference. No fault codes or warning lights,battery 4 months old and sounds like it would...
  19. 2008 BMW X5 E70 3.0D No Start / Will Crank But Not Start

    BMW X Series - Tech Talk For All Gen Of X Series
    Hi folks, New to the forum so please bare with me, i have a 2008 BMW X5 E70, and after leaving it parked up for a few months and after the snow, it seems not to start, it will crank over but no start. So my diagnosis... 1. I tried using starting fluid and it starts until you keep spraying...
  20. BMW 520D Crank pulley

    BMW Guides and How To's
    Hi all My son has a BMW520D 1997 with the N47 engine and the crankshaft pulley has broken - rubber split. Do I need any spacial tools to remove and replace a new pulley? The pulley does not have a keyway so will the engine timing be altered just by removing the single retaining bolt please...
Top