BMW Forums : BimmerForums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 500 Results
  1. General BMW Discussions
    I have a 2015 420d, i would like to code it out with ESYS. Do i have to unplug the complet module, or if i take out the FUSE is enough?
  2. BMW 3 Series Forum - Technical Talk on the BMW E46
    Hello all, I have an 2004 E46 318ci and I have been getting an EML light on the dash which resets when engine is turned off and on again but after a while this lead to the engine management light being on and staying on. I took it to a garage and had the codes read (about 6 of them popped up)...
  3. General BMW Discussions
    Hi, Just curious, does anyone know exactly what unplugging the MAF sensor does on a diesel? I imagine it will stop dpf regen and reset fuel adaption values to default while it can’t read the MAF. Is there anything else unplugging modifies or disables?
  4. General BMW Discussions
    Recently purchased a 2008 BMW E93 M Sport with 101k miles on the clock. Owned the car for two weeks and on 3 separate occasions a red oil pressure light has come on. I've driven around 700 miles since owning the car and driven less than 5 miles with the red oil pressure light on. The clutch on...
  5. General BMW Discussions
    Water pump went on the cars, so removed the EGR and pump but noticed a oil leak which I think is coming from a sensor just above the EGR housing. I have attached a picture of it, can some tell me what it is so i can get replace?
  6. BMW X Series - Tech Talk For All Gen Of X Series
    I've just finished repairing a snapped lower timing chain (or so I thought). Everything seemed to go together just fine mechanically. Tried starting it up - turns but no fire. After finally getting ISTA+ working turns out 'EWS Tampering' fault was recorded from having the battery disconnected...
  7. Auto Electrical Forum
    Hi guys, my 2006 E92 has xenon headlights which have recently started oscillating up and down. Fault code 9CB4 was present (rear ride height sensor) so I've changed the rear ride height sensor twice, firstly with a new Febi Bilstein part which made no difference, and secondly with a new BMW...
  8. BMW 3 Series - Tech Talk For All Gen Of 3 Series
    So my wife's E90 318i has started to judder alot when driving, especially when it's in low gears with little acceleration. If you carry on driving it, it also goes into limp mode. The traction light is constantly flashing and sometimes it'll throw up the ABS light and red handbrake light...
  9. Auto Electrical Forum
    I’ve got an electrical issue that I’m coming to my wits end. Happened last year and still not got it resolved. E36 3.0 M3. Track prepared but still road legal. Problem is this When sidelights and headlights are off the indicators work fine but the nearside (UK) sidelight flashes with the left...
  10. BMW 8 Series Forum - Technical Talk on the BMW E31
    Help Oil level sensor has melted the earth wire on top of the engin On the harness to the oil level sensor with the ignition on engin not running as doesn't start now Pin 1 has 3.66v Pin 2 is earth Pin 3 has 12v Is this correct Do i have faulty sensor causing the fire or is it the modual...
  11. General BMW Discussions
    Hi, I have a 59 plate 3 series that I'm having nothing but problems with! I thought it was sorted when I spent £400 on it last month for abs sensors, various plugs and coils. I've not had a pick of bother with it since..... until yesterday. I was driving along, only around 25mph when the red...
  12. BMW 8 Series Forum - Technical Talk on the BMW E31
    Does anyone know what this sensor does and part number Been to bmw
  13. Auto Electrical Forum
    Hi There, Can anyone tell me what this sensor is for? It is located in the driver's side front splash guard. See photo. Thanks Austin
  14. BMW 3 Series Forum - Technical Talk on the BMW E46
    I had an engine warning light on my e46 had it code read it said bank 1 and bank 2 to lean so had both lambda sensors changed £250 fitted still getting engine warning light bank 1 and bank 2 lean and on tick over at lights and parking up the revs going up and down i know they were fitted my pal...
  15. BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi all so I check my codes after I get the start stop error appear . I get the code brake vacuum sensor , signal 2FD3. Seems this is quite common . Is it a diy repair or shop job ? How do I go about it ? Cheers
  16. BMW 3 Series Forum - Technical Talk on the BMW E46
    I’ll be driving my 2001 325i and all of the sudden it feels like the drivers side front wheel grabs for a second and then lets go. Then the yellow dash DSC and “Brake” light will come on and stay on until I shut the car off. They usually reset. Occasionally, when driving, the yellow DSC light...
  17. Auto Electrical Forum
    Hi, I hope somebody can help, car is a 2003 E46 330i. I have had to replace the starter motor. (nightmare!) during the removal of the inlet manifold I managed to accidentally pull the wires out of the coolant temperature sensor connector. I've managed to salvage the connector and remove both...
  18. BMW 6 Series - Tech Talk E24,E63,E64,F12,F13
    where is location of low pressure sensor on bmw645 engine anyone ?
  19. BMW 3 Series - Tech Talk For All Gen Of 3 Series
    Hi folks :) This fault came up today, with a warning next to it saying "Pending Fault" Does that mean that the sensor hasn't actually gone, but i about to? I cleared it, and it hasn't come back yet after another 5 or 10 miles of driving..
  20. BMW 3 Series - Tech Talk For All Gen Of 3 Series
    I have a 2006 diesel E91 320d which suddenly started running rough, then wouldn't start. It has a fault code 3EC1 showing. I have seen videos of the camshaft sensor being removed on the petrol engines but can't find the sensor on my diesel engine. Does anyone know where it is located?
1-20 of 500 Results
Top