Trying to get this to work but keep getting this message
apicheckjpbstatus: error #100
I've followed the instructions on page one - their is one small part that i don't seem to have the feature on the laptop
Now change the transmit and receive settings in the drop down boxes to 2048 for both transmit and receive
This is the box i get at this stage
Does anyone have any idea what has gone wrong as the software is loaded but this error message keep popping up
at a guess your either on the incorrect port to be adjusting the settings to start with or you havent actually installed/setup the driver for the usb cable correctly or ya trying to do it without the cable plugged in...
and is that windows XP? cos if it isnt then why are you following INPA instructions for XP?
I'll double check everything again regards to the lead - is XP running SP3
that screen is like your trying to set up a standard serial port not a usb serial conversion port..
Does anything jump out to you that indicates being wrong
wot cable are you using and where was it sourced from?
it's not got an FDTI chipset in it for starters its got a CH340 chipset by the look of it...and it will never work...
you have to have a Vagcom with FDTI FT232RL chipset...
Same issue as Bram here.. Looks like I've got to order the other cable.. I purchased this one:
New USB Cable KKL 409.1 VW/AUDI OBD2 OBD OBDII VAG COM 409 VW/Audi/Seat/Skoda UK | eBay
seems to be there is some crappy ones going about with no FDTI chipset in them....
another cheap FDTi vagcom
|« Previous Thread | Next Thread »|