BMW Forums : BimmerForums banner

HELP!!! INPA Expert Problem Coding!!

2K views 7 replies 4 participants last post by  wv1jc 
#1 ·
Hi,

I was reading my error codes on INPA which was ok.

I then read a forum about regenerating through INPA Expert, like a idiot I loaded INPA Expert - File - load profile - then selected E60 fron 2 of the dropdowns!!

CHASIS NOT MATCHED!!

Then car went crazy, on ignition, no lights then flickering like blackpool lights - car wont start - wont lock - no response whatsoever - then alarm goes off!

Please help me!! What I done???
 
#2 ·
Hi, jus an update!!

When the INPA Expert is been used it has to be connected to a additional power supply as it uses alot of power, therefore it drained my battery.

I charged battery for 3 hours, bam it started again! Everything ok!!

Swirlflaps, turbo vac pipes, vortex filter, egr valve, glow plugs and controllers next job when i get time.

Got dpf issues due to no regen as glowplug controller wont allow the regen process to run.

Thanks
 
#8 ·
I replaced 6 glowplugs and controller, swirlflaps, turbo vac pipes and crankcase breather/filter

Cleared faults, going to force DPF regeneration - any guides step by step??

Also what is the following as they keep coming back:

4B10 rough controller
4B90 rail pressure monitoring
4560 rail pressure plas

what should my injector values be on INPA

Thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top