..... I'm getting thin enough on top without pulling any more hair out over this !
I have an e39 (2000 my) - i have 2 keys - One is in pieces & will start the car if you hold the transponer near the antenna ring...
The other is complete but wont start the car... It's identified as key 0 on INPA or Progman and the stated reason is "Changing Code" (all the other functions are OK)- do i simply need to re-sync it ? - if so......
Question - how do you do a ews re-sync? (i tried EWS Adjustment) - It runs then throws up a trouble code & states it was'nt done
- I did the changes.iso thing - when i start the prog it tells me the batt v is 14.0v - go anywhere else & it reverts back to 12.4 - i know this will stop you programming but the EWS adjustment continues past that stage..
Am i heading in the right direction or do i need to be doing somthing else?
when you do a key list it states leys 0-3 as active & used the only difference is 1-3 start as 04 00 00 00 00 00 00 and key 0 is 08 00 00 00 00 00 00
Guess i need a step by step guide - I'm starting to glaze over with this so i may have missed somthing stupid...
If i try an ews re-sync in INPA it throws an "scripting error code"
Thanks in advance - Steve