I purchased this set of leads to run on my newer laptop that has no serial port.
Load everything up as per the instructions and then tested INPA. INPA worked fine and after following the instructions having problems with the DIS v57, with respect that the diaghead configuration screen no free diagnstic head found. Did some searching on here and the internet in general.
What I found was that when changing the EBIABAS.INI file IP Address to the one in the 55 page document (192.168.68.1) did not work, changing it to 192.168.68.30 did work.
The Diaghead can now be seen with the IP address of 192.168.68.1 in the config screen.
Use the same IP address in SSS as well and the interface IP address is again 192.168.68.1.
Now it seems to work fine I will now try it properly on the car tonight and let you know how it goes.