BMW Forums : BimmerForums banner

2007 E90 320d - Ignition disabled

4K views 22 replies 4 participants last post by  dailydoggy 
#1 ·
I recently replaced my brake pads, and when I tried to reset the service light I ended up with a brake pad failure light. So I bought INPA software and tried to reset it from this. I then found my aircon and rear screen heater did not work and my remote locking was screwed up. I connected up again and now my car won't start!!!! The engine just turns over but doesn't run.

The INPA is in German so I didn't understand what I was doing

And yes before you say it I am a dickhead

Can anyone help me at least get the ignition enabled again so I can take it to the dealer
 
#23 ·
yav prodded and mucked around with summat in a foreign language pressing and excecuting things when you didn't even know what ya was lookin at or doing..

its gonna be an expensive trip to a dealers or a decent BMW indy garage i think before ya make it even worse..
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top