I am trying to replace the electrical wiring connector which connects to the heating/aircon final stage resistor unit. The connector on the car at the moment has a broken clip on one side so won’t fully grip the plug on the FSR and keeps working loose. I have obtained a new connector from a BMW breaker as the local main dealer could only supply it as part of a complete system wiring loom! I was hoping I could simply switch the wires over but it is not proving that easy. I have attached a couple of pics of the new connector which show I have removed the sliding retaining clip. I thought this would allow me to simply pull the wires and ‘sleeves’ out but they don’t want to budge. Does anyone know how to remove them? If I can’t swap the wires over I can always cut the set on the car and use some crimping clips to join them to the few inches of wire on the replacement connector. But I would prefer to swap them over if possible.