So, read flash codes and have the above error.
There are two parts to this post
1) Been lazy but not looked under the car, but assuming I have pre and post cat sensors or one on each branch which one is this one? I could manufacture extra faults by disconnecting to see but not keen on that.
2) Replacement sensors, note all prices are approximate and not quoted
- £79 from a local factor
- £58 Euro car parts
- £47 Euro car parts without multiplug i.e. attach crimp or solder
- £20 Ebay
Now I'm not above soldering on a connector, I'm not a fan of crimped connectors, to save a few pounds. However, if doing that to save a few pounds is there any good reason not to go for the £20 units?
Lambda sensors are pretty generic I think, not to mention the amount of times I have bought unbranded EFI bits to find the same part number moulded in, ok not on BM so far, so I'm thinking generics are probably cheap as they don't have to make a thousand different wire lengths and keep a dozen different ends in stock.
My preference would be to solder and use some resin heat shrink, unless this has issues.
I suppose I should price the BM part as at the moment my thinking is, if buying generic £20 generic beats £80 generic.