my gear knob is starting to look a bit tatty and i'ver never used carbon sheets before.Just ordered some 3M sheets off ebay any tips from the carbon junkies on here would be appreciated please
Do you have a heat gu? This will help with slight stretch on the carbon sheet and enable u to bend it around corners well. Also get a really sharp blade (Scalpel) to help trimming...
Lots of help on youtube mate Thats what I used when I did some bits in my car
How much sheeting do you need to do an E46 then? The door trims, dash trims, gearlever surround only (I won't be doing my steering wheel!).
I've seen 122cm wide by 30cm, 122x50cm or 122x100cm... any ideas?
I want to do my door trims too so will need to order some more. Get the biggest you can afford Paddy. Sometimes you mess up the first go so its good to have a little extra...
what i would say is that 3m stuff has a directional weave if you know what i mean so make sure you plan all the bits you do so that the weave all goes the same way!
|« Previous Thread | Next Thread »|